5
General Instructions
Pre-Rinse Installation:
1. Shut off water supply and drain
lines.Apply Teflon tape or pipe joint
compound to threads on both ends of
no.
24
. Screw no.
24
into no.
1
and hand
tighten.
2. Slide no.
25
down no.
24
(about
halfway) and tighten temporarily.
3. Screw no
.
23
down on no
.
24
and hand
tighten, then tighten no.
23
with a wrench,
which will also tighten no.
24
. Make sure
to align no
.
25
over center of sink, directly
in front of no.
24
while tightening.
Note: If new no.
22
is being installed on
no.
21
, make sure it’s installed in the
upright position.
4. Adjust position of no.
25
so that no.
20
hangs loosely in it without straining
no.
21
or no
.
22
.
5. Turn on water supply and check for
leaks.
See back pages for similar unit
installations.
Caution: Turn off water supply at
base faucet when not in use.
25
24
22
21
20
23
24
BOTTOM
25
