Tandon TM100-1, Operating And Service Manual

Page: 81 / 105

FIGURE 6-18
TRACK 0 CABLE HARNESSING
4. Remove the mounting screw attaching
the assembly to the chassis (Figure 6-20).
5. Remove the assembly, pulling it toward
the front of the drive, and slipping it out
from the adjustment screw (Figure 6-19).
REPLACEMENT
1. Put the new assembly into the drive.
2. Push this assembly toward the rear of
the drive, and slip the bracket into the
adjustm ent screw (Figure 6-19).
3. Ensure there are no cables underneath
the assembly.
4. Install the mounting screw (Figure 6-20)
attaching the assembly to the bottom of
the chassis.
5. Attach a tie wrap to the cable harness at
the bottom of the chassis.
6. Tie wrap the bundle of cables located at
the back of the drive motor.
7. Reinstall the Logic circuit board.
8. Adjust the Track 0 Switch Assembly.
6-23