TCWS.54NG04.C1 181208-16
7.
Secure the burner tray to legs using
four screws (Fig. #7)
NOTE: a light will aid aligning the holes
in the tray with the leg
8.
Install the right burner by tipping into
location trough and slipping the venturi
tube over the orifi ce. Test for
connection by lifting at a location pin
on the right side of the burner. Repeat
with left burner. (Fig. #8)
CAUTION: The burners should be tightly
butted up against each other at the center
to ensure correct operation.
9.
Place sand into the burner tray and
brush smooth. Use caution not to get
sand near the burner ports. (Fig. #9)
NOTE: check air shutter for correct
fuel setting before proceeding
further. Both burners are the same.
Fully closed for natural gas.
13/64 (0.2)” open for LP.
Fig #8
Fig #9
Fig #7
5
Summary of Contents for TCWS.54NG04.C1
Page 14: ...Notes...
Page 15: ...Notes...
