Document No.
D&TQP0302-11(0)
Revision No.
01
Page
15 of 22
8. Special
Consideration
9.1 All the supported timing modes (includes LCD Panel mode) are described in chapter8.
(Optimized with TANDBERG’s requirement signal timing)
9.2 This model have plug & play feature of DDC 1, DDC2B. This function is operating when the
monitor is connected to a system compatible with VESA DDC standard.
The DDC data structure is based on VESA DDC 1.3 standard
9.3 You can adjust and change the several function without buttons, by using RS232C serial
communication protocol through 9pin D-Sub (Female) connector.
(Refer to RS232C serial interface protocol)
9.4 RS232C chain connection with several monitor is available through RS232C IN/OUT connector.
(ex, TANDBERG’s T3 system, Max 9 monitor)
So you can adjust and change the several monitor individually or at the same time.
9. Applicable
Regulations
:
The
products
described
in
this
specification
must
meet
all
applicable safety
and
regulatory
requirements
as
listed
in
this
chapter.
10.1 Approvals-Europe(CE Mark)
Type Requirement
CE Mark
All Products must have CE mark
LVD Directive
73/23/EEC
Standards for LVD:
IEC/EN 60950-1 2
nd
ed
CB according to IEC60950-1 incl all the different nation deviations.
Special requirements.
•
Ambient temperature 40
℃
•
CI. 5. 1 Touch current
Max 0.5mA touch current with switch “ON” and “OFF” position.
•
Approved to 3,000 meter altitude above sea level.
EMC Directive
89/336/EEC
EN 55022 : 2005 (Class B)
EN 55024 : 1998 Incl A1/A2
EN 61000-3-2 : 2000
EN 61000-3-3 : 1995 Incl A1
Testing:
All testing must be performed in accredited test laboratory
EMC testing must be performed in laboratory appointed as competent body
according to the EMC directive
RoHS Directive Product must comply with the European RoHS Directive 2002/95/EC
Signed declarations or test reports is accepted to document compliance.
10.2 Approvals-North America(USA/Canada : UL, FCC Mark)
Type Requirement
Product must be tested and approved according to relevant standard
Electrical Safety
CSA 60950-1-07 2
nd
ed / UL 60950-1 2
nd
ed
Approval agency must be accredited as an NRTL
EMC
EMC Requirements according to FCC15B (Class B)
