Tandberg Data
StorageLoader
Introduction
This guide is designed to act as a guideline to enable quick installation of the
Tandberg StorageLoader series. For additional product and operation details please
refer to the Tandberg Data StorageLoader Installation and User manual P/N 433061,
which is found on the resource CD included with the unit.
Installation of the StorageLoader may be quickly summarized in steps as follows:
•
Unpack the StorageLoader
•
Install the StorageLoader in a rack
•
Connect the power cable to the StorageLoader
•
Turn the StorageLoader on
•
Remove the transport lock by following the instructions displayed on the front
panel
•
Select the appropriate SCSI ID’s and unit options
•
Connect the SCSI interface cable, and optionally the Ethernet cable
•
Install the backup application software and configure it for use with the
StorageLoader
•
Load recording media into the removable magazines
In order to complete full installation of the StorageLoader the following additional
materials are required.
•
Simple hand tools (small Phillips screwdriver).
•
Tool for emergency magazine removal (included in accessory kit)
•
SCSI Host adapter card with 68 pin wide HD or VHDC connector
•
Tape Application software which is verified with the StorageLoader
•
Up to 8 pieces of the appropriate recording media to “stock” the StorageLoader
to full tape capacity.
4
StorageLoader Quick Installation Guide
