Tandberg Data StorageLibrary T40 T40, Installation And User Manual

Page: 44 / 95

36 Configuring the Library
Static IP address
Static default gateway
Static subnet mask
Enable/disable RMI interface
Enable/disable RMI FW upgrade
Use the Network configuration screen to configure the library network settings. The network settings
set the connectivity of the library to the network.
If Dynamic Host Configuration Protocol (DHCP) is enabled on your network, enabling DHCP will
automatically configure the library network settings. If DHCP is not enabled on your network, you
need to manually configure the IP address, subnet mask, and default gateway settings.
Details on network settings include:
The library can be set to DHCP mode, or the IP address, subnet mask, and default gateway must
be configured. DHCP is selected by default.
The IP Address, Default Gateway, and Subnet Mask text boxes are limited to numeric characters.
Each of the four groups cannot have a value greater than 255.
The paths to open the appropriate screens are:
From the RMI select Setup > Network
After the initial setup of your library you can access the Network configuration screens directly from
both the FPI and the RMI:
From the RMI, select Setup > Network
From the FPI, select Setup > Network
Remote Access
If you choose to complete the Setup Wizard remotely, the FPI wizard automatically displays the
Network settings you need to access the RMI.
The network settings are also viewable from the front panel Reports > Remote Management Info
screen. The screen provides the information necessary to access the remote management interface.
The screen lists the IP address of the library. Use this IP address to access the remote management
interface using a web browser. When typing the IP address into a web browser, make sure to precede
it with http:// (for example,
http://123.123.123.123 ).
Applying a License Key
A license key can be purchased and applied to the library to increase the number of available slots
from 24 to 40. The license key is applied during the initial configuration of the library or at any time in
the future.
An instruction sheet that describes how to use the license key is provided in the accessory kit.
Contact Technical Support for more information on obtaining a license key. For contact information,
see
Getting More Information or Help .
Note
The license key is made up of to 5 printable characters. The license key is case-
sensitive.
The license key is verified when it is applied to the library. It cannot be transferred to another library.
The license key can be entered when running the Setup Wizard. After the initial setup of your library
you can later access the Activate License configuration screens directly: