26
OF
28
4.
Press
Modify
. Press
or
until the selection arrow (
) points to the desired
configuration. Press
Select
.
Note:
This menu option requires input for
all
of the tape drives installed in the library. If
you press “Back” before configuring all the tape drives, the configuration
selection will not change.
5.
Press
OK
.
6.
Repeat the process for each tape drive installed.
7.
Press
Back
(as needed) to return to the Home screen.
R
ESUMING
O
PERATION
1.
Power the library off (press the
0
on the back of the unit—after setting the new tape
drive configuration).
2.
Connect the interface cables.
Connect the Fibre Channel cable (or cables if you installed more than one Fibre Channel
tape drive).
or...
Connect the SCSI cable (or cables if you installed more than one tape drive) and a
terminator (if needed).
You must install a terminator on the device at the physical end of the SCSI bus. If
one of the tape drives in the library terminates the SCSI bus, you must install the
required terminator on one of the tape drive’s SCSI connectors.
If there are additional devices on the SCSI bus, ensure that only the device at the
physical end of the bus is terminated.
Select Drive 1
HP LTO-2 HalfHigh
IBM LTO-3 FullHigh
Select
Back
!
Important
Both LTO-2 and LTO-3 tape drives require an Ultra 3 or LVD
160 terminator to function properly on the SCSI bus. An
inadequate terminator will result in various SCSI bus issues,
including bus hangs and Read/Write failures. See the individual
Product Manuals at
www.tandberg.com
for detailed
information.
