Tanco A Series, Operator'S Handbook Manual, Page: 24 / 72

Tanco Autowrap - A200 EH
Operator’s Manual
23
The Display Menu
The Display menu is divided into 3 sections. At the top level are the settings used during the daily work with the machine – i.e. Store totals and No. of Wraps. The Operator Setup’
section enables the operator to perform adjustments to the machine operation – e.g. time duration and time delay settings during the automatic cycle. The ‘Technician Setup’ menu is not
normally accessible to the operator without a PIN access code. ‘Technician Setup’ is not covered by this manual.Use the 4-way switch to navigate the menu. Each menu screen indicates
which keys to press to make the settings. The instrument will default back to the main operating display after 30 seconds if no other key is pressed.
Here is a summary of the display menu;
NOTE: There are additional sequences selectable in the Operator Setup menu but not shown in the table. These sequences are for wrapper models to which this manual does not apply.
Please refer to section 3 for further explanation of the Operator Setup functions given in the table above
7. EH CONTROLLER INFORMATION
See Section 3.0
for Settings
Default
Film Break Alarm (Optional on A200EH)
If the film breaks or runs out during the wrapping cycle, the instrument will sound an audible alarm and the display will show ‘FILM BREAK’.
Wrapping will stop at this point. Press R3 when you are ready to resume the auto-wrap cycle.