Tanco 580-J, Operator'S Handbook Manual

Page: 28 / 44

- 28 -
Tanco Autowrap 580-S/J
Operator’s manual
9. OPERATING INSTRUCTIONS
9.1 Fitting roll of film.

When loading a plastic roll, first ensure the top cone (2) is pushed up to latched position, then push back the
Stretch rollers (3) until held in position by locking catch (4). .

Place the Roll on the Bottom Cone and release the top latch (5) by pushing the wire cord (1).

Pull the film between the rollers on the pre-stretcher in the direction of the arrow. (See fig. 5-2). (See also the
sticker on the dispenser).

Release the locking catch and allow the rollers to lie against the roll of film. Pull the film from the roll and tie
it to the bale.
9.2 Set the bale wrap indicator to the correct setting for the size of the bale being wrapped and the width of film being used see
table 1 for list of some recommended setting.
9.3
Power down Lift Arm until wheel is clear of ground and adjust wheel outward to appropriate setting for bale weight.
9.4
Check Turntable speed is approx. 25 r.p.m. NOTE: Speed in excess of 30 r.p.m. will void warranty.
9.5
Position turntable with cut and start unit, facing front of machine.
9.6
Attach film tag end to gripper section of cut and start unit.
9.7
Rotate turntable anticlockwise through 90 degrees and stop turntable with cut and start unit opposite to lift arm.
9.8
Locate bale on Lift arm, then raise lift arm and gently roll bale onto turntable. Lower arm.
9.9
Start wrapping, turntable rotating anticlockwise. Film tension is automatically set so that width of film applied to the bale
stays at an approx. width of 400mm for 500mm wide film roll and 600mm for 750mm wide film roll.
The 580 S
model is equipped with an AutoStop function, which enables semi-automatic operation of the
machine. Once the turntable has made one revolution the spool Joystick is held in position by the bale
counter until the preset number of rev.s has been achieved. The Joystick is then automatically released
and the turntable stops in the correct “Off-Loading” position.
9.10 On reaching the last wrap revolution a beeping signal from bale wrap indicator sounds (required number of revolution has
been reached) to warn the operator that the wrap cycle is complete. Check that the cut and start unit is facing towards front