tams elektronik S88-4, Manual

Page: 27 / 32

!
S88-4 English
9. Check list for troubleshooting

Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: one or more components are soldered incorrectly.
à
In case you have mounted the module from a kit, perform a
visual check (
à
section 6.) and if necessary, remedy the faults.
Otherwise send in the module for repair.

The central unit, the memory or the interface do not show the
proper status.
Possible cause: The connection(s) between the feedback module and
feedback modules connected in series or the digital device are
interrupted.
à
Check the connections. When using a ribbon cable,
check as well, if the connecting socket of the ribbon cable is put on
in the right direction.
Possible cause: The connection between the input and the mass
contact is interrupted.
à
Check the connections.

The control unit / the memory / the interface always displays in a
specific situation the same false status.
Possible cause: You have assigned another address to the S88-4
module than required. Check the address.


The control unit / the memory / the interface display does not
display the status of one module.
Possible cause: You have assigned an address to a S88-4 module
that is occupied by another S88-4 module or a standard module.

Check the addresses.
Page 27