LD-G-3 / LD-W-3
English
Page 37
§
The locomotive lighting does not correspond to its direction of
travel.
Possible cause: The forward and backward light connections have
been exchanged.
à
Check the connections.
Possible cause: The connections of the motor to the points X10 and
X11 have been exchanged.
à
Exchange the connections.
§
A lamp flickers (this is not a defect).
Possible cause: The lamp is connected with one side to locomotive ground.
à
If you do not want the lamp to flicker, disconnect it from
locomotive ground, insulate it and connect it to the return
conductor (point X1 or X6).
§
The locomotive does not run in digital mode.
Possible cause: The locomotive address is not set correctly.
à
Programm the locomotive address again (see section
"Programming the locomotive address").
§
The locomotive does not run in analogue mode.
Possible cause: The locomotive is set to digital mode.
à
Change to
analogue mode.
If you cannot find the problem, please return the decoder for repair
(address on the cover page).
Manufacturer's note
According to DIN VDE 0869, the person who brings the circuit into
operation by extension or mounting into a housing is the manufacturer
of the product. If he sells the product to another person he is
responsible for passing on all the relevant papers and to give his name
and address.
Certification
This product conforms with the EC- directive 89/336/EWG on
electromagnetic radiation and is therefore CE certified.
Summary of Contents for LD-G-3
Page 20: ...LD G 3 LD W 3 English Page 39 ...