FD-R
Basic
English
Page 47
In order to change the CVs or the registers used in both the FD-R
Basic
and a decoder with the same address you can proceed as follows as
well:
RailCom on
Reading out the decoder´s settings.
RailCom off
Programming the function decoder area of the
FD-R
Basic
. NB: Simultaneously you alter the respective
CVs or registers of the decoder with the same address.
RailCom on
Programming the decoder with the data read out
before. The settings are saved in the RailCom area of
the FD-R
Basic
only.
Advice: When not using the FD-R
Basic
as a
RailCom transmitter, RailCom
should be switched off.
Programming the RailCom area
TIP: When using the FD-R
Basic
both as a function decoder and as
RailCom transmitter, first program the function decoder area as
described in the previous section.
In order to program the RailCom area of the FD-R
Basic
, RailCom must be
switched
on
in CV#29 (DCC format) or in register #7 (Motorola
format). All settings made for this area can be fed back via RailCom to
special detectors. You can save in this RailCom area either the values of
CVs #1 to #205 of a DCC decoder (that is not compatible to RailCom)
or the registers #1 to #205 of a Motorola decoder (that is not
compatible to RailCom) or the settings from the function decoder area
of
the FD-R
Basic
.