tams
elektronik
!
!
English
Booster B-3
6. Connecting the B-3
Please note:
Do not block the flow of air over the heat sink at the booster´s back
surface, otherwise the booster can overheat.
Risk of fire!
When
connecting the booster be sure to keep sufficient distance to other
devices, walls, and the like.
Connecting the central unit
It is possible to connect the booster to
the interface of the central unit for a Märklin-compatible booster
(with a 5-pin connecting cable) or
the DCC booster interface of the central unit (with a 3-pin connecting
cable).
The enclosed cable is intended for connecting the booster to the
interface of a Märklin-compatible booster. It can be used for connecting
the booster to the central unit MasterControl. The booster configuration
of the MasterControl has to be set to "short circuit polarity: positive
(MM)" (= factory setting).
The booster B-3 has two Märklin-booster ports and two DCC-booster
ports to be used at choice. Please make sure that the pin assignment of
the central unit´s booster interface corresponds to that of the booster
port.
Please note:
When using the Märklin compatible booster port, the connection cable
between booster and control unit should not exceed a length of 1 m.
Otherwise a malfunction of the short circuit feedback can occur. When
using the DCC conform booster port it is possible to use a longer
connection cable.
Page 12
Summary of Contents for Booster B-3
Page 1: ...t a m s e l e k t r o n i k Manual Booster B 3 Item no 40 19327 tams elektronik n n n ...
Page 21: ...t a m s e l e k t r o n i k Booster B 3 English Page 21 ...
Page 22: ...t a m s e l e k t r o n i k English Booster B 3 Page 22 ...
Page 23: ...t a m s e l e k t r o n i k Booster B 3 English Page 23 ...
