Starting the Software
Starting the Software
Turn on the power for the camera that is connected to the computer.
1. Double-click on the "130NT-P-CM Parameter Setting Ver1.0.exe"
icon that you copied onto your computer.
A window for selecting the COM port appears.
2. Select the COM port connected to this computer, and click [OK].
Select a
COM port
Click
Selecting [ON] will display the
latest settings saved in the
camera. (Initial settings will be
shown on the first run.)
Saves the current settings
to the camera's EEPROM.
The main configuration window appears.
Checking the COM Port to Use
1
Right-click on [My Computer] and select [Properties].
2
In the [System Properties] window, select [Hardware] → [Device Manager].
3
In the [Device Manager] window, verify that "Silicon Labs CP 11x USB to
UART Bridge (COMxx)" is displayed under [Ports (COM & LPT)].
The COM
p
ort
[c
om
xx]
c
an be use
d
.
Make sure that the port in the Parameter Setting window match
-
es with the computer.
If there is a mismatch, you will not be able to control the camera.
Caution
■
Summary of Contents for 180-View 180NT-P-CM
