LAMINATING PROCEDURES
1. Push the handle to the “DOWN” position to engage the rollers and make sure the Run/Stop switch
is in “STOP” position. To start laminating, put the Run/Stop switch on “RUN” position.
2. To put the lamination temporarily on hold without turning off the machine, user can turn the motor
control switch to “STOP” position. This will cause the motor to stop running and the film will
stop feeding.
3. To resume the lamination job, turn the switch to the “RUN” position again.
(2) HOT FOIL LAMINATION
LOADING THE FILM
Unpack the upper rods. Load the foil film onto the rods by turning the top rod clockwise as you push
the rods through. Make sure to leave equal lengths of rod out of each end using the guide marks to
correctly position the roll of film.
Load the rods on the laminator.
Note: you cannot interchange the upper and lower rods.
THREADING THE FILM
Read the threading card supplied
with this laminator. Do not mistake the stabilizer bar for the idler roller.
1. To thread the foil film through the “hot rollers” & “pull rollers”, please pull the handle to the “UP”
position to separate upper & lower hot rollers.
2. Push the film through the rollers by using the threading card provided.
3. Make sure the film is correctly threaded based on the threading guide. A threading diagram is also
located on the right side panel of the machine.
HOW TO DO HOT FOIL STAMPING