Z-Block Manual version 1.1
Page 6
Application Examples
1) Vertical Multi-Zone Installation
The Tamas Z-Block can be installed in a vertical
Configuration. When installing multiple
Z-Block modules vertically, the optional Vent
Fitting (part # 025-0021) must be used for the
air vent or thermistor sensor. This fitting is a
1/8” MPT thread which can house any
manufacturers automatic or manual Air Vent.
When used for venting purposes, it is
required that the user drill a 5mm (0.2”)
hole in the bottom of the fitting. The user
must also drill a 5mm (0.2”) hole in the
bottom of the end cap that the fitting will
be installed in. (Refer to FIG 4. on page 5)
e.g. Vertical Installation with 180° End Connection (#025-0005), and
End Cap Vent Fitting.
180° End Connector
This component can be fitted
with a multitude of optional
accessories, such as Air Vents,
Thermistors and Purge Valves.
Drill 5mm (0.2”) hole
in bottom of fitting.
FIG 6.
FIG 7.
FIG 8.
