TallyGenicom 6605, User Manual

Page: 69 / 212

Vertical Format Units (VFU) Submenu
69
Vertical Format Units (VFU) Submenu
This submenu is used for setting VFU specifics. The Level 2 headings are as
follows:
VFU Enable
A Vertical Format Unit is a means for loading sets of vertical tabs. These
vertical tabs define various parameters of a form. This parameter applies only
to the emulations which make explicit use of the VFU channels.
•
Disable (default).
•
Enable. Causes the printer to use the last loaded EVFU instead of using
the Form Length, Top Margin, and Bottom Margin settings. When an
EVFU is loaded, this parameter is automatically set to Enabled.
VT Channel (Vertical Tab Channel)
You can select which VFU Channel is designated as the Vertical Tab
Channel. This parameter applies only to the emulations which make explicit
use of the VFU channels. Selections are 1 - 12 and Unused. The default
depends on the emulation as defined in the tables under the Emulation
selection parameter, page 55.
Skip When
This parameter applies only to the emulations which make explicit use of the
VFU channels. This parameter designates where the Skip Length distance
will begin, before or after the Bottom of Form channel. The Skip location is
determined by using the designated Bottom-of-Form Channel in the
downloaded VFU. The Skip When parameter only functions when the VFU
Environment is enabled. The default depends on the emulation as defined in
the table under the Emulation selection parameter.
VFU
(from page 57)
VFU
Enable
VT
Channel
Skip
When
Disable*
Enable
2*
1-12
Unused
Before*
After
* = Factory Default