TallyGenicom 2365, User Manual

Page: 76 / 186

The Menu User guide
66
Data format (Format) This parameter serves to define the number of data bits, the parity
check for received data bytes and the number of stop bits per data
byte.
Press Format (3) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: see table below
Default Setting:
8 Bit No 1 Stop
1 Sets the number of data bits: You can select 7 or 8.
2 The parity test for received data bytes can be selected. NO cau-
ses transmission in both directions without parity bit. If EVEN or
ODD is selected, the bytes are checked if they have even or odd
parity. The selection of MARK or SPACE causes a data byte
transmission with parity bit, but without checking the received da-
ta. Transmission data with parity bit is always marked with
1
( MARK ) or 0 ( SPACE ).
3 Selects one or two stop bits per data byte.
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Baud Format
Online
Setup
2 1 3 4
Back Next
8bit No 1Stop*
Online
Setup
Set < > Exit
2 1 3 4
1 number of data bits 2 parity test 3 number of stop bits
7 Bit No 2 Stop
7 Bit Even 1 Stop
7 Bit Odd 1 Stop
7 Bit Even 2 Stop
7 Bit Odd 2 Stop
7 Bit Mark 1 Stop
7 Bit Spc 1 Stop
7 Bit Mark 2 Stop
7 Bit Spc 2 Stop
8 Bit No 1 Stop
8 Bit No 2 Stop
8 Bit Even 1 Stop
8 Bit Odd 1 Stop
8 Bit Mark 1 Stop
8 Bit Spc 1 Stop