1-14
1.6.2
System Level Occasional Execution Commands
These commands are executed as soon as the printer receives them.
They begin with "STX," i.e. [02].
Setting date and time
[02] A
Setting feedback character transmission validness
[02] a
Date and time transmission request
[02] B
Setting paper length for continuous paper
[02] c
Setting two-page edit mode (double buffer)
[02] d
Changing number of prints for edited format
[02] E
Setting edge sensor selection
[02] e
Label one sheet feed
[02] F
Setting peeling (cutting) position
[02] f
Printing edited or formerly-printed format
[02] G
Graphics data block input command
[02] I
TrueType fonts downloading command
[02] i
Pause per label printing
[02] J
Extension system command (printer settings)
[02] KD
Extension system command (setting peeling or cutting position)
[02] Kf
Setting Y-code-transmission-to-serial-port request
[02] k
Specifying printing contents setting start
[02] L
Setting maximum label length
[02] M
Changing units from inch to metric system
[02] m
Changing units from metric to inch system
[02] n
Setting printing position
[02] O
Paper cut
[02] o
Setting dump mode start
[02] P
Pause in occasional execution
[02] p
Clearing all memory module contents
[02] Q
Clearing memory module contents
[02] q
Setting reflective paper sensor selection
[02] r
Setting paper feed speed
[02] S
Setting one-page edit mode (single buffer)
[02] s
