ETP-CI-4G-V
Cellular Interface for Verizon
Installation Instructions
Page
2
of
5
Rev. 12/10/2020
Copyright 2020 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone, LLC.
All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
IV.
Installing the Antenna
The
ETP-CI-4G-V
Cellular Interface includes a remote-mounting MIMO antenna. The remote-mounting MIMO
antenna should be attached to the Talk-A-Phone enclosure (e.g., ETP-MTE-W, ETP-MT/R-SOLAR, ETP-MT/R-
PCS, etc.) via the built-in antenna mounting hole. To install the remote-mounting MIMO antenna, please follow
the separate antenna mount instructions included with the remote-mounting MIMO antenna.
Figure 1.
An example of mounting the remote-mounting MIMO antenna onto the cap of an ETP-MT/R-PCS tower.
The remote-mounting MIMO antenna will be connected to the
ETP-CI-4G-V
Cellular Interface through the ports
listed in
Section V.2
.
V. Installing the Cellular Interface
1. The front panel of the
ETP-CI-4G-V
Cellular Interface provides the following:
(1) Cellular signal strength indicator;
(2) LED indicators for
POWER
,
STATUS, CELL
, and
GPS
;
(3)
DATA
port reserved for future use;
(4)
MODE
button reserved for future use;
(5)
RESET
button for rebooting the cellular interface;
(6)
PHONE-FXS
port for connecting to an ETP-500 Series Phone.
Figure 2.
Front panel of the
ETP-CI-4G-V
Cellular Interface.
