Talkaphone AOR-8 Installation Manual Download Page 8

 

Area of Rescue Command Unit

 

Installation Guide 

Model AOR-8 / Model AOR-16

 

Page 

8

 of 

10

 

 

  Rev. 6/28/2017

 

 

Copyright 2017 Talk-A-Phone Co.

 

• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com. 

 

 

All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-
Phone Co.  All rights reserved.  All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any 
approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated. 

VI. 

Operating Instructions 

1. 

General Information 
When a push button on the Talkaphone Analog Call Station is pressed it will automatically 
either ring the local phone or dial out using the phone line connected to the Telco 

IN

” port 

according to how the particular consolidator which it is connected is programmed.  If the phone 
line is being shared with another device (see p.5, sharing a line), the consolidator will seize the 
line on behalf of the Analog Call Station. 

 

When a call comes in to the 

AOR-8 / AOR-16 

unit , an LED will light indicating which Analog 

Call Station is calling in.  If a call is already being answered, any other calls which come in will 
cause the appropriate LED to blink to indicate they are awaiting an open line.  As soon as the 
initial call has been completed, any calls that were waiting will be put through in the order in 
which they were placed. 

 
2. 

Calling Talkaphone Analog Call Stations through the Area of Rescue Command Unit 
To call from a remote phone, dial the telephone number of the Consolidator.  To call from the 
local phone, simply pick up the phone and select the phone line corresponding to the 
appropriate consolidator.  In either case, you will hear 3 beeps when the consolidator is ready. 
 
Enter the code to route to an Emergency Phone, *4X* where X= Port #1-8.  There will be a 
short pause and then the Analog Call Station will answer with a series of tones. 
 
For more information on Analog Call Stations, consult the Emergency/Information Phone 
manual. 

 
3. 

Answering the Analog Call Stations 
When a call comes in on either the local phone or a remote phone, the consolidators are 
effectively transparent.  That is, there will exist an open line of communication to the Analog 
Call Station from the moment the call is answered. 

 

 

 

Summary of Contents for AOR-8











Reviews: