Area of Rescue Command Unit
Installation Guide
Model AOR-8 / Model AOR-16
Page
7
of
10
Rev. 6/28/2017
Copyright 2017 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-
Phone Co. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any
approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Programming the Analog Call Stations
Once each Consolidator has been programmed, each Talkaphone Analog Call Station must be
programmed individually. A call can be routed to the desired phone port by entering the following
code:
*4X*
Routes to Analog Call Station in port number X (X=1-8)
For details on programming the Talkaphone Analog Call Stations, refer to the Installation &
Operation Manual for Emergency/Information Phones. (Note: if the Consolidator is in Remote Mode
or Day/Night Mode and your remote phone line is a PBX extension, be sure to program the
emergency phones for Mode 2. See Emergency Phone Manual, pages 11 and 15 for more
information on Modes).
Code Summary
Command
Function
*31* …[up to 8 digits]*
Guard
Access
Code
entry
for
phone
programming
(Default Code is *31**)
*30* …[up
to 8 digits]*
Master Access Code entry to change Guard Access Code or
Master Access Code
(Default Code is *30*12345678*)
*30*14725836*
Resets Consolidator programming to factory defaults
*32* …[up to 8 digits]*
Programs and stores a new Master Access Code
*33* …[up to 8 digits]*
Programs and stores a new Guard Access Code
*34* …[up to 2 digits]*
Sets number of rings before consolidator picks up when it is dialed
*62*
Remote Mode (default)
*37*
Local Mode
*63*
Day/Night Mode
*35*
In Day/Night Mode, call LOCAL PHONE then TELCO IN
*36*
In Day/Night Mode, call TELCO IN then LOCAL PHONE
*39*...[1 or 2]*
Program the type of phone line in the TELCO IN
*39*1* for ordinary phone lines (default)
*39*2* for PBX lines
*4...[1-8]*
Routes to Analog Call Stations in Port #1-8
