ETP-120
Series Phone
Installation & Operation Manual
Page
17
of
27
Rev. 7/2/2021
Copyright 2021 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
F
Lap Counter.
The lap counter
determines how many times the
ETP-120 unit will cycle through
its list of up to five (5) phone
numbers (or up to three (3)
phone numbers if calling through
the Auxiliary Input) before it
stops the dialing process and
hangs up.
When all of the programmed
phone numbers have been
dialed, the lap counter
increments and the dialing
process repeats. When the lap
counter has been met, the
dialing process stops and the
ETP-120 unit hangs up.
When the lap counter is disabled
(default), if the ETP-120 unit is
programmed to dial the next
number on ring-no-answer
and/or busy signal, the ETP-120
unit will continuously call its
programmed phone numbers
indefinitely until the call is
answered.
0
Disabled
[Default]
1
1 time
2
2 times
…
…
8
8 times
9
9 times
Recording the Voice Message
The voice message is recorded from a standard touch-tone telephone through an analog PBX
extension or analog PSTN line.
Typically, physical location information is provided through this voice message to identify the unit to the
answering point. For example,
“233 South Wacker, northeast stairwell B, 8th floor requires assistance.
Press
*
to repeat this message”.
1. Call into the ETP-120 Series Call Station and access programming mode (see
Section 6.2
Accessing Programming Mode, p.11
).
2. Enter this code to initiate recording, wait for a single beep, and begin speaking:
* 4
NOTE:
The maximum duration for a voice message is 16 seconds.
3. Press any key to stop recording.
NOTE:
After recording, the voice message will automatically play back as a preview.
4. Enter this code to preview the voice message again:
* 5
5. Enter this code to clear the voice message:
* 3
NOTE:
The voice message feature is
NOT
supported on calls placed via the Auxiliary Input.
