ETP-120
Series Phone
Installation & Operation Manual
Page
12
of
27
Rev. 7/2/2021
Copyright 2021 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Security Code
When
Mode Configuration DIP Switch #3
is in the
ON
position, the ETP-120 Series Call Station will
require a security code before it can be programmed.
The default security code is:
827827
(or
TAPTAP
)
Talkaphone highly recommends that this security code be changed from the default value. To change
the security code, follow these steps:
1. Access programming mode as outlined in
Section 3.2
.
2. Enter:
☐☐☐☐☐☐
# 19
3. Hang up or enter this code to disconnect:
# 7
If the security code is lost or forgotten, either reprogram the security code when
Mode Configuration
DIP Switch #3
is set to the
OFF
position or reset the unit to factory defaults.
NOTE:
The security code must be comprised of six (6) numeric digits.
