TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
www.talex-sj.pl
9
Securing the linkage assembly (three-point linkage) pins of the mower should be made only
by means of conventional collateral in the form of pins. Work with other security is
prohibited!
Due to the natural wear and tear the state and completeness of cutting machine tools should
be controlled, using the recommendations described in the chapter.
Operations and maintenance:
Upon receipt and transport of the mower check whether the machine has not been damaged
by checking its technical condition.
Presence of people under the raised mower is forbidden, they could be crushed by structural
elements.
By adjusting do not put your fingers and limbs between components of the machine.
During operation and regulation operator of the vehicle, which is cooperating with the
mower must take care that no one approaches the machine and stays at a distance of less
than 50 m from a working mower.
When turning or reversing, manoeuvring the machine, adequate visibility should be secured
or help of suitably trained person should be used.
It is forbidden to stay, service between the vehicle and the mower when the engine is
running.
Take special care when working on slopes.
When making turns and returns turn off the PTO (power take-off shaft).
During operation, do not allow the PTO speed to exceed 540 rev/min. and the driving speed
must be adapted to the required work.
Using a damaged or incomplete jointed telescopic shaft is prohibited. In particular, it is
prohibited to work without guards of moving parts.
Never leave the vehicle with the engine running. Before leaving the driver's seat (the cab)
lower the machine to the ground, switch off the engine of the vehicle, remove the ignition
key, engage the parking brake.
