TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c, 77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
29
6.5. Adjusting the mower
After setting the mower in working position, the sliding discs should be positioned parallel to
the ground.
In the position, the pin of the scythe-connector (Fig. 16, item 1) should be placed in the
centre of the groove in the connector (Fig. 16, item 2).
Figure 17 Proper positioning of the mower
In order to change the cutting height:
1)
Position the mower for transportation and lift it to the upper position, immobilize the
tractor, switch off its engine.
2)
Secure the mower against falling off, additionally support one of the discs,
3)
Unscrew the bolts (Fig. 17, item 1) and remove the sliding disc (Fig. 17, item 5)
4)
Unscrew the bolts (Fig. 17, item 3) fixing the resistance disc (Fig. 17, item 2) and
remove the disc.
5)
Adjust the cutting height (Fig. 17, item 4 - spacer rings),
6)
Assemble the parts in reverse order.
Execute the above steps on the second element of the cutter unit’s working section.
