6
USER GUIDE
EN
board. Screw gently until it
blocks (M6 18mm).
Place the red shim at the back
of the fuselage. The shim should
be aligned with the fuselage,
pointing backwards. Place the
stabilizer wing on top of it with
the winglets down (opposite
side of the front wing), secure
it with the 2 smaller screws (M6
16mm).
You can now fix the fuselage
to the e-mast, below the
propulsion, with the three long
remaining screws (M6 30mm).
Before each session, make
sure the screws of the fuselage
are strongly tightened to the
e-mast.
Mast
To fix the e-mast to the board,
prepare the 4 T-Nuts and the 4
screws - M6 25mm.
Slide the 4 T-Nuts inside the rail
on the bottom side of the board
(flat side inside).
To fix the mast of the e-foil on
your board, insert the connector
of the e-mast in the oval hole
between the rail and place the
top plate of the mast against
the board (with the spinning
propeller toward the back of
the board), in the middle of the
rails.
Start screwing the dedicated
screws (M6 25mm) inside the
T-Nuts. Slide the screws inside
the notches until you reach the
good position in the top plate.
Screw diagonally (so that the
screws are vertical) until it
blocks.
Electronic Speed Control (ESC)
Open the top cover of the
board.
Unscrew the connector’s
protections of the e-mast and
ESC.
Plug the connector of the
e-mast to the ESC (notches
down).
The connection must be
smooth, without forcing.
When you reach the first notch
screw slightly until you reach
the second notch and then
tighten again.
Battery
Place the battery in the board
and secure it firmly with the
strap.
Unscrew the connector’s
protections of the mast and
battery.
Plug the mast connector to
the battery connector with the
notches on the right side.
Again, the connection must go
smoothly, without forcing.
When you reach the first notch
