Takstar WDA-500, User Manual

Page: 34 / 40

33
Audio output
Audio input
The second one
The current operating one
D. Serial connection
WDA-500 supports serial connection for multiple speaker reinforcement simultaneously.
Link the out connector of the first speaker with the in connector of the second one via
Φ3.5mm audio cable.
E. Matching frequency
This product has been matched well in factory. If there is signal interference, match
again according to the steps below:
1 ． Matching
① At first, mic and speaker are in turning off status.
② Turn on wireless microphone. Disassemble the mic tail tube. Keep pressing
“HI/LO”button for 3 seconds. When the screen flashes quickly, release it. Turn
on the speaker at once for matching. If the speaker is not urned on in 10 seconds,
the matching fails.
③ It takes about 10 seconds for matching. When wireless mic frequency turns
flashing to lighting up and the speaker screen displays MIC, this means the
matching is successful. If the speaker screen does not display MIC, this means the
matching is unsuccessful. Matching them again according to the way mentioned
above.
2 ． Changing frequency
Turn on the speaker and mic. Press “HI/LO”button to change frequency. The screen
displays “00.0 MHz”with the number changing.