Takstar M-2F Series, Manual

Page: 19 / 24

18
V. Volume Adjustment
Press and hold S/O button for 3 seconds to enter volume adjustment mode. Press ▲ or ▼
buttons to increase or decrease the volume, respectively. Press SET button to confirm and save
the settings and exit.
VI. System Lock/Unlock Operation
When powered on, press and hold SET button for 2 seconds to lock the receiver. The screen
displays a lock symbol, and when the receiver is locked, all other function buttons are disabled.
Press and hold SET button for 2 seconds again to unlock, the lock symbol on the screen will
disappear, and the other button functions will be restored.
VII. System Menu Settings
To access the system menu settings, press and hold ▲ key while powering on the device.
The screen will display "-FSET-" and after 1 second, it will automatically switch to the flickering
submenu SQL. Press SET key to cycle through the submenus SQL, RFP, LED, and ID. Within each
submenu, use ▲ or ▼ keys to adjust the settings. Pressing the IR key during the operation to save
and exit.
① SQL refers to the receiver sensitivity, with 11 levels ranging from -95dB to -75dB in 2dB
increments. Use ▲ or ▼ keys to select the desired sensitivity level. Higher SQ settings improve
anti-interference capability but may reduce the transmission distance, so adjust it as you see fit.
② RFP refers to the transmission power. After frequency pairing, select H for high power
transmission and L for low power transmission. Use ▲ or ▼ keys to make the selection.
③ LED controls the backlight timeout duration. After frequency pairing, selecting ON will keep
the backlight on, while selecting OFF will delay the backlight from turning off. Use ▲ or ▼ keys to
make the selection.
④ ID determines whether pilot signal is enabled. Selecting ON will enable pilot signal, and
selecting OFF will disable it. Use ▲ or ▼ keys to make the selection. When the pilot signal is
detected, the corresponding PILOT characters will appear on the screen; otherwise, they will
not be displayed. The pilot signal function is enabled by default upon power-on.
M-2F SERIES
Wireless Microphone