Takstar M-2F Series, Manual

Page: 15 / 24

14
LCD Screen Interface
① RF Indicator: Displays the received RF
signal strength.
② AF Indicator: Displays the dynamic of the
AF signal.
③ Battery Level Indicator: Shows the current
battery level of the transmitter.
④ Frequency and Channel Indicator: Displays
the frequency or channel of the current selection. The value beneath FREQUENCY
MHZ indicates the receiver frequency. It can be switched to display the CHANNEL info.
⑤ Lock Indicator: Shows the locked status.
⑥ ANT A and ANT B Indicator: Shows which antenna is being used in the diversity system.
When the mic moves, this indicator may switch between ANT A and ANT B based on the
signal conditions.
⑦ PILOT Status Indicator: Appears on screen when pilot signal is enabled; Disappears when
pilot signal is disabled. Pilot signal should be enabled during normal use.
⑧ MUTE Indicator: Shows whether the receiver is in receiving state. Appears if there is no
valid signal received, in which case the audio output is muted. Disappears if there is valid
signal received, which unmutes the audio output. The mute indicator appears in the
following three situations:
1) No RF signal is detected.
2) Pilot signal enabled on the receiver, but mic is not turned on, which requires re-sync.
3) Any key operation is performed on the receiver.
1
4
5 6
7
2 3
6 8
Handheld Transmitter
① Power Switch: Press to turn on the mic power,
press and hold to turn it off.
② Infrared Sync Window: Used in conjunction with the
SET key on the receiver to transmit channel parameters
to the transmitter.
③ LCD Display: Shows the current working channel and battery level.
④ Battery Compartment: Used to install two AA batteries.
(Pay attention to the battery polarity)
⑤ Antenna: Do not obstruct the antenna during use to
avoid affecting the transmission distance
1
2
3
4
5
M-2F SERIES
Wireless Microphone