TAKIMA TKFOS-10-A, Instruction Manual

Page: 13 / 19

12
• P. 6, item 8
– Loosen Allen screws (30).
– Push the splitting wedge (16) upwards up to
the stop.
– Re-tighten the Allen screws.
Turning over into circular bench saw
position
DANGER!
Risk of injury!
W hen used as a circular b ench saw, the saw
blade is freely accessible. Splitting wedge
and swarf cover must always be installed.
• P. 6, item 8
– Loosen Allen screws (30).
– Push the splitting wedge (16) downwards up
to the stop.
– Re-tighten the Allen screws.
• P. 6, item 9
– Allow the safety bolts (12) to engage b y
turning clockwise.
– Gently push tool arm (3) to the stop.
– Actuate the release lever (8) and carefully
turn over the saw bench.
– Allow the saw bench to securely engage.
– Removing the protective box.
• P. 7, item 10
– Attach the hand wheel (21).
– Rotate the saw blade fully upwards.
– I nsert the swarf cover (17) on the splitting
wedge until the bolts (31) audibly engage.
– Attach the dust bag to the swarf cover or
connect a swarf extractor.
Note:
T he use of a swarf extractor is recommended
when processing larger volumes.
Operation
Check before switching on!
DANGER!
Risk of injury!
T he product must only be put into operation if
no defects are found. Ensure that any
defective parts are replaced before the product
is used again.
Check the safe condition of the device:
– Check whether there are any visible defects.
– Check whether all parts of the product are
firmly attached.
– Check that the product is stable.
– Check that the safety devices are in faultless
condition.
– Check whether the saw bench is securely
engaged.
– Check whether the incline setting locking
screw is firmly tightened.
Crosscut sawing function
• T urning over into crosscut saw position.
Page 11
Setting the mitre angle
The mitre angle can be set steplessly between
-45° to 45°.
DANGER!
Risk of injury!
Always tighten the workpiece stop clamping
lever before sawing.
• P. 7, item 11