Main Features
Coverage of light beams
Detection line
Receiver
Transmitter
(1) DOUBLE MODULATION
(2) WIDE BEAM
(3) QUAD HIGH POWER BEAM
(4) LOW CURRENT CONSUMPTION
(5) ECOLOGY
(6) INSECT/ WATER PREVENT
(7) ANTI-BIRD SPIKE
(8) DRIP-PROOF HOUSING
(9) DUAL RING SIGHT
(10) TARGET COLOR
(11) INCREASED ANGLE
ADJUSTMENT ALLOWANCE
(13) WIRELESS ALIGNMENT CHECKER
(12) SOLAR BATTERY CORRESPONDENCE
(14) LIGHTNING PROTECTION
Keeps birds and small animals away from the
sensor, helping to reduce false alarms.
Prevents rain and snow from streaming down
the front side of housing, helping to avoid false
alarm.
The vivid color of the internal structure can be
recognized easily from the far end in the beam
alignment procedure.
The color differs between a transmitter and a
receiver which helps easy installation and
checking.
Enables easy and accurate beam alignment.
(Sold separately)
Minimize the damage by the induced surge
through wirings.
It may stand 10000V under normal mode,
15000V under common mode.
It can be used with solar battery unit in a site
without a power supply. It becomes possible to
install without wiring work.
Vertically ±20˚ compared with previous version.
It may adapt to the slope installation fl exibly.
Enables better and clear view for easy beam
alignment.
This device is an opposed type photoelectric beam sensor that consists of
a photo transmitter that transmits infrared light, and a photo receiver
for the transmitted light, as shown in the illustration on the right.
The infrared light transmitted from the transmitter expands in a cone
shape, while the light beams enter the receiver.
The straight line that connects the transmitter with the receiver is the
detection line.
If the detection line is obstructed (light is obstructed for more than 0.05
– 0.7 seconds), the receiver detects this break in the light beams, and
outputs a signal.
The current consumption of this products is a little. so it can be used
with solar battery unit in a site without a power supply.
Even in case wired, the thin wire is enough for wiring due to less
current consumption. It is good for moneywise.
In order to ensure that the detection line has sufficient margin of
sensitivity, adjust the direction of the light beams before placing the
system into operation. Providing sufficient margin of sensitivity reduces
the occurrence of malfunction caused by dense fog, heavy rain, frost,
snow, and other such weather conditions.
Double modulated beams are designed to
distinguish the external lights.
It increases the reliability in the outdoor security
system.
The pitch between upper beam and lower one is
widened more than old models.
False alarm by birds and falling leaves reduces
drastically.
The beam power is 100 times of the minimum
requirement.
The beam distance is 10 times of the described
specifi cation.
This high power beam also realizes the reliability
against the harsh conditions like fog, snow, heavy
rain.
50% less than remaining models. The battery size
may reduce, wiring diameter may lessen,
installation cost may decrease.
RoHS adapted – Environment friendly. Free from
Lead, Mercury, Cadmium, Hexavalent chromium,
Polybrominated biphenyl, Polybrominated
diphenyl ether.
Anti-insect bushing and special gasket enable
IP65 rated tight housing.
Instruction Manual
LOW CURRENT PHOTOELECTRIC BEAM SENSOR
PXB-100SW : OUTDOOR 330ft (100m)
Thank you for purchasing this product.
Read this instruction manual before using the product to make sure that you use it correctly.
①
