N11A27;20/37
- 20 -
Table 6-5 [OSD menu 4] setting
●
Selection of Operating cursor
It can select the cursor to be changed and to display the settings. It can be changed by entering the argument [H’01 to
H’04] to the communication command “H’45” as follows.
H’01 : to display the data of cursor1 (White)
H’02 : to display the data of cursor2(Blue)
H’03 : to display the data of cursor3 (Green)
H’04 : to display the data of cursor4 (Red)
●
Horizontal data Start / Width
It can set the horizontal start position and the horizontal width of each cursor in pixels. It can be changed by entering an
argument to the communication command H’A0 to H’BF. Refer to the command list on chapter 7.
(Note) The sum of the coordinate data of the horizontal start position and the horizontal width should not exceed the
setting range of “H’0018 ~ H’064C”.
Setting of horizontal start position
In case of cross-s haped c urs or,
the width is not changed even if it were s et.
Dis play area of the monitor
Dis play area of the monitor
Setti ng of horiz ontal width
●
Vertical data Start / Width
It can set the vertical start position and the vertical width of each cursor in pixels. It can be changed by entering an
argument to the communication command H’A0 to H’BF. Refer to the command list on chapter 7.
(Note) The sum of the coordinate data of the vertical start position and the vertical width should not exceed the
setting range of “H’0007 ~ H’04C4”.
Displ ay area of the monitor
Display area of the monitor
Setti ng of
Verti cal
start position
In c as e of cross-shaped curs or,
the width is not c hanged ev en if it were set.
Setti ng of verti cal wi dt h
Communication
command
Set contents
Argument data
Default
Setting range
H’45
Operating cursor
(CURSOR)
H’01
H’01 to H’04
H’
✳✳
Horizontal data Start / Width
(X_DATA SX/W)
-
H’0018 to H’064C
H’
✳✳
Vertical data Start / Width
(Y_DATA SY/W)
-
H’0007 to H’04C4
H’40
Cursor 1 Set (White) (CURSOR 1)
H’00
H’01 to H’03
H’41
Cursor 2 Set (Blue) (CURSOR 2)
H’00
H’01 to H’03
H’42
Cursor 3 Set (Green) (CURSOR 3)
H’00
H’01 to H’03
H’43
Cursor 4 Set (Red) (CURSOR 4)
H’00
H’01 to H’03