Takara Belmont DIVAN-Z AB-DVZF, Operation Manual

Page: 23 / 40

Preset switches (P1, P2)
Control panel (Right)
Preset switches (P1 to P3)
Control panel (Left)
Press any switch you want
to set.
Press either switch
you want to set.
Although the setting positions of the preset switches are previously set, you can change to the positions to
match your needs and preferences.
Adjusting preset positions
1. Move the chair to the desired seat, backrest and legrest positions, and turn the power
switch off.
2.
①
While pressing the preset switch you want to set,
②
Turn on the power switch,
③
Press and hold the preset switch until a beep sound is generated (for about 3 seconds).
Is set at that position.
3. First, return to the exit/entry position with the auto return switch, then use the preset
switch for which you have changed the setting to make sure that the chair moves to the
position you have set.
Set the positions of the preset function with a person sitting in the chair.
The chair is equipped with a shockless device. Accordingly, the set positions vary slightly when a person
sits in the chair if position setting is performed without a person sitting in the chair.
Power switch
②
①
①
Moving the Chair to Preset Positions
Preset settings are not possible when the chair is within approximately 5 cm of the lower limit position and
the backrest is reclined more than approximately 140 degrees (to prevent the chair body or backrest
pinching feet and other objects).
If the setting operation is performed in this position, a 'beep' will sound and the setting will be set at a
position approximately 5 cm higher than the lower chair limit position.
23