Assembling the Care Dry G Stand
(4) Attach the stand cover.
Stand cover
Pass the stand cover through the height-adjustment pipe and fit it into the stand.
The stand cover should be attached in a certain direction. Orient it as shown in the figure below.
CAUTION
Eight catches on the stand cover
Align the mark on the stand cover with the pedal.
Mark
4
(3) Fully tighten the screws to fasten the height-adjustment pipe to the
four-legged stand.
After aligning the height-adjustment pipe in (2),
temporarily remove the weight. Then, fully tighten
the screws that fasten the height-adjustment pipe in
the position that allows the weight to properly fit in.
After tightening them up, attach the
weight again.
●
Make sure that the weight is properly oriented. Otherwise, when you attach the stand cover
at the end, it will not fit in place.
●
Be sure to tighten the screws firmly. Otherwise, the main unit may rattle.
* Make sure that
the mark comes
right above the
pedal.
* As shown in the figure above, attach the stand cover so
that the hooks on the back side catch the stand.
Weight
Fully tighten the four screws.
