6
Assembly Instructions
Caution
Caution
Caution
Caution
2. Remove the Compression Cap Bolt.
Stand the unit up before removing the cap bolt. Working
on it while leaving it lying flat runs the risk of having the
Support fall out. It may also cause damage to the support.
1) Stand the unit up after attaching the Base Stand.
2) Before proceeding further, fully tighten the Height
Adjustment Knob.
Loosening the Height Adjustment Knob while the unit is
in a compressed state will cause it to rise suddenly.
Exercise care in handling the unit.
3) Remove the cap bolt using the included wrench and remove
the washer and sleeve as shown in the illustration.
Be sure to remove the washer and sleeve.
Leaving them attached to the Support may cause damage
to the product.
4) Loosen the Height Adjustment Knob.
Be sure that the main unit can be moved up and down.
3. Attaching the Nape Bar
1) Firmly push the Nape Bar into the attachment
holes as far as it will go.
Insert into the holes
up to the mark.
Mark
Nape Bar
Be sure that the left and right sides of the Nape Bar have
been fully inserted up to the ìmarksî.
Push in the Nape Bar until both ends have
gone as far as they can go.
Position adjustment cannot be done when
the unit is in use.
2) Use the included wrench to tighten the screws
(left and right) that have been left loosely tightened.
3) After tightening the screws put the caps (left and right)
over the screw holes.
Nape Bar
Nape Pad
Cap
Screw
Wrench
Sleeve
Washer
Cap Bolt
Wrench
Height
Adjustment Knob
