-
11 -
5. Operation of Transmitter
5.1 Direct connection mode
A specific route can be detected in Direct Connection mode. Use the two
pronged connecting cables (3 m/10 ft.) which are included in the carrying case
as a standard accessory.
When the connecting cable is connected to the Transmitter, Direct Connection mode is
automatically selected.
Red clip
Wire cable / Metal pipe
Bottom lamp is blinking,
before clips are connected
Check the grounded point. Find the best place to
ground to have a good signal loop indication.
Clean connection area if rusted or painted
to ensure a good electrical connection.
Note: Place the Earth/Ground as far as
possible and at a right angle to the
target line.
Black clip
Ground stake
Attach the Direct connecting cable
90
Note: Keep Receiver at least 5m/16ft. away from
the signal connection point
5m /16 ft.
Connect the cable clips to the target line and ground stake.
