www.takacat.com
Takacat Owner’s LX Series Manual - 2022
7. Unroll the inflatable floor and insert into its position. There is no need to get it
perfectly under each hull tube, but the rear of the floor should be flush with the
Lower Transom Bar.
Insert D-Rings on the bottom of the air deck floor, through the slots in the boat floor
fabric layer. Lash the two D-Rings together with the included webbing strap.
8. Inflate the floor to 10 psi. While inflating the airdeck floor, be sure to pause and
walk on the floor to push it into place. Don’t forget to activate the check valve
by pressing down on the centre pin and turning it ¼ turn in either direction. If it
is popped up it wont let any air escape. When taking the pump out, do it quickly
as you wont loose much air.
NB: If you are finding the valve leaking a little air after pumping up, this is
common as the boats are handmade and the valves can loosen when packing
for shipping. Just use the valve and tighten a ¼ turn and it should tighten the
valve again.
