TAJIMA TEHX-C, User Manual

Page: 107 / 140

CHAPTER 9 OUTLINE OF FUNCTIONS
100
10. SATIN STITCH
11. TRACE
This function expands satin stitch length.
Density for distinction
When a distance (a) is 1 mm or less, the
machine recognizes it as a satin stitch.
Data to be added
A half (c) of the set value in parameter “32.
Satin Stitch (Data to add) [mm]” is added
both sides of stitch (b).
a
b
c c
a: Distance b: Stitch width c: 1/2 of the setting value
(GC02)
This function makes the frame move along the outer circumference of the design
that has been set.
Trace makes the frame move to each apex of
the outer circumference of the design as if a
rubber ring was hanged at each apex.
When there is an offset position, the frame
will move to offset start position --
Offset start position
Middle position
1
2
3
4
5
6
: Design start position
When repeat setting is made, whole designs
will be traced after tracing the first design
only.
Repeat of design