Hovercraft Battery Installation
4.Replace BATTERY DOOR by aligning the door
and compartment, lowering rear of door into
place and turning LATCHES to locked position
(Do the opposite process indicated in 1.)
5.Check operation by turning power switch to
ON and then OFF again. Power switch is
located on the top right of hovercraft. Lift Fan
should go ON and OFF. If not, remove and
reinsert the battery plug. Turn the power
switch OFF to save power while changing
battery whenever possible.
1.Confirm that the main switch is OFF. Turn
LATCHES on vehicle BATTERY DOOR, lift door
at rear and remove.
2.Insert fully charged BATTERY PACK into
battery compartment as shown. Observe
position of wire as shown.
3.Firmly insert BATTERY PLUG all the way into
SOCKET as shown. Make sure the “key”
(bump) on plug is facing downward to fit into
notch in socket.
Only use exclusive 6.0V rechargeable Ni-MH
battery Pack (included) for proper function &
safety.
*Check whether the rechargeable batteries are
fully charged before insertion.
*For charging process, please read the
BATTERY CHARGING INSTRUCTIONS.
