Chapter 3
Front Panel and Menu Tree
38
On
AT%G1
/Enable (Dial Line Default)
Off
AT%G2
/Disable (Leased Line Default)
Remote Access
ATS27=n
(bit3)
Enable the modem to monitor and control the
remote modem through the secondary channel
On
/enable remote access function
Off
/disable remote access function (default)
Dynamic Range
ATS28=n
(bit0)
Select the dynamic range of receiving signal.
-12..-44dBm
/-12 to -44 dBm (Default)
-2 ..-35 dBm
/-2 to -35 dBm
3.5.6
CONFIG DTE MENU
Item Name
Command
Description
DTE Speed
300 bps
600 bps
1200 bps
1800 bps
2400 bps
3600 bps
4800 bps
7200 bps
9600 bps
12000 bps
14400 bps
16800 bps
19200 bps
21600 bps
24000 bps
26400 bps
28800 bps
31200 bps
33600 bps
38400 bps
57600 bps
AT
This setting is used to determine DTE speed
when auto speed conversion is ON in V.42 /
MNP / normal mode.
*When using direct mode and all the
synchronous modes, this setting will not
available and DTE speed will be determined by
modem speed, DTE speed = modem speed.
*The throughput is improved by using data
compression; enhance this set higher than the
modem speed is suggested to enable more
effective operation.
*When use “AT” command and auto baud rate
detects function "ON", this setting will be
replaced by identified speed.
*The Auto baud rate function can detect all the
listed DTE speed.
/Default = 57600 bps.