2. Volume control
Adjust the volume by the “
▲
/
▼
” buttons. The volume will
be increased/ decreased until it reached the
maximum/minimum and the MIC indicator will flash.
3.
Auto. shut down mode
When enable the auto. Shut down mode, the microphone
will turn off if no speaking voice is detected in 15 minutes.
Steps:
a. Press and hold simultaneously the “
▲
” and the
microphone on/off buttons for more than 2 seconds,
all signal indicators shall cycle flashed two times;
b. Switch the mode by pressing the “…”/”F” button. The
number of signal indicators indicates the current
working mode :
Auto. Shut down
Number of indicators
On
1
Off
0
c. Press the microphone on/off button to confirm;
d. Mic. will power off automatically and please reboot it
to apply the setting.
4.
PTT mode (only for TES-5606)
Press the “F” button to talk when the PTT mode is on, the
default is off.
Steps:
a. Press and hold simultaneously the “
▼
” and the
microphone on/off buttons for more than 2 seconds,
all signal indicators shall cycle flashed two times;
b. Switch the mode by pressing the”F” button. The BAT
indicator will turn red when PTT mode is on:
c. Press the microphone on/off button to save.
5.
Audio input
External audio devices (such as MP3) or microphone can
be connected via the Ø3.5 mm AUDIO IN interface and
the microphone will be muted automatically. The volume
can be adjusted by the “
▲
/
▼
” buttons.
6.
PPT slide
TES-568xBX connects to PC, use the TES-560x
microphone can realize the remote control PPT slide.
Steps:
a. Press the”…”/”F” button to switch to PPT mode, the
PPT indicator turn red
b. Press the
“▲
/
▼
”
button to turn pages of the PPT.
7.
Charging
TES-560x built-in Lithium battery, it can be charged by
USB port, TES-5604 can also be charged by
TES-5604CS series charging station.
When charging, microphone shut down automatically and
the BAT indicator indicates the charging status:
Charging status
BAT indicator
Charging
Green (blink)
Charged
Green (on)
Exceptional
Yellow (blink)
8.
Fitting the microphone
Put the hanging piece of the neck lanyard into the slot
and adjust the looped part’s length of the neck
lanyard to find a suitable position for the speaker and
for a perfect sound quality.
Note:
Microphones with the same frequency channel
cannot be used in one classroom at the same
time.
The default frequency is 2.33 MHz.
The maximal number of active microphones is
according to the type of the system.
Note:
The default PPT mode is off.
37
