2.6.7 Alarm Setting
Enable alarm function or not.
a). Use the “
/
”
button to select “Yes” or “No”;
b).
Press the "MENU" button to save and return to the
upper level menu.
2.6.8 Operation Language Setting
Select the LCD display language from simplified
Chinese, Traditional Chinese, English, etc. Other
languages can be added by the user through
LCD_Designer software operation.
a) Press the "
/
" button to select the LCD display
language;
b) Press the "MENU" button to save and return to
upper level menu.
2.6.9 Network Setting
“Network” includes three submenus:
→“IP Address”
→“Subnet Mask”
→“Gateway”
1) Setting up unique “IP Address” for the
transmitter:
•
Use the “
/
” button to switch between the four
numbers;
•
Use the “MENU” button to edit the selected
number;
•
Use the “
/
” button to decrease/increase the
number (press and hold the "
/
" button will
adjust the numeric value quickly);
•
Use the “EXIT” to return to the upper level menu.
2) Setting up “Subnet Mask” and “Gateway”:
Same chronological order as for the “IP address” set
up.
2.6.10 Use Testing Audio Signal
The transmitter goes to testing mode and testing tone
will be distributed to all output channels.
Use the “MENU” button or “EXIT” button to stop the
testing mode.
2.6.11 Parameters Backup/Restore
System parameters can be backed up or restored through
the panel USB port. Make sure that the USB disk is
properly connected, otherwise it will prompt “Please insert
the USB disk.”
a). Press the “
/
” button to select “Backup” or
“Restore”;
If “Backup” is selected, system parameters can
be backed up;
If “Restore” is selected, system parameters can
be restored;
b). Press the “MENU” button to confirm and to go to
selected menu item;
c). Return to upper level menu after backup and reboot
after recovery.
Note
:
“IP address”, “Subnet Mask” and “Gateway”
of the system software should correspond
with the above transmitter settings, else
connection error will occur;
All menu setup except “Network” and “Input
sen.” use the “MENU” button to exit saving
changes, and use “EXIT” to exit discarding
changes.
24