16
3.3.13.
lang
Selects the language used to display messages during the telnet
or console connection and on the LCD:
¡
lang 0 -
Polish
¡
lang 1
- English
3.3.14.
masq
The “masq” command displays a list of masqueraded
connections. The list consists of source and destination addresses, the
port assigned by the router, the time remaining to the removal of an entry
in case of connection inactivity and the amount of remaining free table
entries that may be used for new connections. Both ports and IP
addresses are printed as hexadecimal numbers.
3.3.15.
mem
“Mem” shows the memory usage statistics. The “free” entry is the
most important - it shows how much free memory is left.
3.3.16.
netstat
Shows a list of active TCP connections.
3.3.17.
ping
Checks the availability of a device with selected IP address. For
example:
ping 10.0.0.2
gives the time necessary to send packet to the 10.0.0.2 station
and back or reports its unavailability. Press Ctrl+C to stop the pinging
process.
3.3.18.
ppp
The “ppp” command sets up the PPP parameters when the WAN
link works in the synchronous PPP mode. Following options are available
(the <port> parameter should be set to “ppp0”):
¡
ppp <port> defroute on
17
¡
ppp <port> defroute off
- the command enables and disables,
respectively, adding of the default route through the PPP interface
after the connection is established
¡
ppp <port> mtu <value>
- sets the maximum packet size that
the router may send through the PPP interface (the final MTU
setting depends also on the MRU setting on the remote router)
¡
ppp <port> mru <value>
- sets the maximum packet size that
the router will accept to receive
¡
ppp
<port>
ip <local address>[:<remote address>]
-
sets the IP addresses used during the PPP connection negotiation
¡
ppp <port> up1 <command>
¡
ppp <port> up2 <command>
¡
ppp <port> up3 <command>
¡
ppp <port> up4 <command> -
the “up1” to “up4” options
allow execution of up to four commands after the PPP link is
established
¡
ppp
<port> d
own1 <command>
¡
ppp
<port> d
own2 <command>
¡
ppp
<port> d
own3 <command>
¡
ppp <port> down4<command>
- the “down1” to “down4”
options allow execution of up to four commands after the PPP link
is broken down
¡
ppp <ppp> user <username> -
sets the username used
during the PPP authorization (if required by the remote router)
¡
ppp <port> password <password>
- sets the password used
during the PPP authorization (if required by the remote router)
¡
ppp
<port>
debug on
¡
ppp
<port>
debug off
- enables and disables, respectively, the
syslog debugging of the PPP link
3.3.19.
prompt
The default "Tahoe>" prompt may be changed to help identifying
the router. Enter
"prompt <new prompt>"
to change the default.
3.3.20.
ps
Show the processes list.
3.3.21.
reboot
Reboots the router. All unsaved changes to the configuration will
be lost.
Summary of Contents for 1800
