©COPYRIGHT 2005 TAHMAZO PRODUCTS PTE LTD
Tahmazo Products Pte Ltd
w:http://www.tahmazo.com
e:[email protected]
126 JOO SENG ROAD, #08-06
GOLDPINE INDUSTRIAL BUILDING.
SINGAPORE 368355
BRUSHLESS MOTOR
ER
2208
K
Winding Sequence Table
Pole Position/Direction
A-in
A-out
B-in
B-out
C-in
C-out
1
3
4
10
9
5
6
12
11
2
8
7
clockwise
counter-clockwise
Step 4
:
For Group A, wind wires
around pole 1 in a clockwise
direction with 10 turns, then
continue to pole 2 and wind
another 10 turns in a counter-
clockwire direction. Wind to
Pole 8 and finally Pole 7 in the
direction given in the above
Winding Sequence Table
Once completed, label the
ends with tape to indicate
Group A.
(See Figure 4)
Step 7:
Ensure each wind is tight
while not to overstretch the
wires. It is suggested to use a
piece of wooden stick to assist
winding. (See Figure 7)
Step 5
:
(See Figure 5)
For Group B, continue winding
from Pole 3,4,10 and ends with
Pole 9 in the direction
according to the Winding
Sequence Table.
Step 6
:
(See Figure 6)
For Group C, continue winding
from Pole 5,6,12 and ends with
Pole 11 in the direction
according to the Winding
Sequence Table.
Step 8:
After every wind over the pole,
ensure all the wires are within
the pole using a small piece of
plastic or wooden apparatus.
(See Figure 8)
Step 9:
After complete winding all 3
groups into the poles, pull
together. A-in & B-out, B-in &
C-out, C-in & A-out
Step 10:
Position group wires at a suitable
location and remove protective
coating with a hobby knife to allow
soldering at that point.
Solder the group wires in 3 sets:
1. A-in & B-out
2. B-in & C-out
3. C-in & A-out
TIP:
While you want the wire to lie in the stator neatly, there is no need to
pull the wires too tightly. Instead rotate the stator in the opposite
direction to the direction of winding.
2
Instruction Manual
