XT-2 Reader Installation Manual & Data Sheet
Doc no. 10-407 02
© TagMaster
18 (26)
A cable for connecting the service interface to a 9-pin PC COM port should be created
as specified in Table 13.
Table 13 Cable specification: PC COM port
↔
Reader Service Interface
9-pin D-sub Connector
(female on cable)
Reader Connector
Pin
Signal
Pin
Signal
2
RXD
1
TX
3
TXD
2
RX
5
GND
3
GND
5.2.8 Isolated Inputs, Group J51
The reader has three isolated optocoupler inputs which are protected from noisy
environments.
Table 14 Isolated Inputs, Group J51
Pin
Signal
Description
1
IN 1A
Input signal 1
2
IN 1C
Input reference 1
3
IN 2A
Input signal 2
4
IN 2C
Input reference 2
5
IN 3A
Input signal 3
6
IN 3C
Input reference 3
5.2.9 Isolated Outputs, Group J52
The reader has two open collector outputs.
Table 15 Isolated Outputs, Group J52
Pin
Signal
Description
1
OUT 1C
Output 1 collector
2
OUT 1E
Output 1 emitter
3
OUT SPL
External supply voltage for the outputs
4
OUT 2C
Output 2 collector
5
OUT 2E
Output 2 emitter
5.2.10 Ethernet, Connector P1
An RJ45 connector labelled P1, with two internal indicators, is provided for Ethernet
connection. The clip for detaching the cable faces upwards from the controller board
surface to allow mid-board mounts. The Ethernet connector has eight pins and the wire
scheme is based on the T568A standard.
Note:
The RJ45 connector will not pass through the cable gland. Pass the Ethernet
cable through the cable gland, before crimping the connector on the cable.
