8
Operation - Basic
1. Plug the Power Cable into the electrical outlet.
2. Switch on the amplifier – press the Power Switch (the Power Switch should be
in the down position). The status LED around the Power Switch should turn blue
in a few seconds. If it does not, it means that the amplifier is working under an
abnormal condition (a protection mode) – turn off the power, unplug the Power
Cable and check whether some of the cables are not short circuited. After fixing
the cables turn the amplifier on.
3. Using the Speaker Selector knob select which group of speakers (A or B or A+B)
you want to use. If you want to use 2 pairs of speakers choose the A+B option.
4. Using the Input Selector knob select which audio source you want to play
(corresponding to the selected input).
5. Switch on your audio source and start playback.
6. Regulate volume on the amplifier to adjust the level of sound.
Note!
High volume levels can damage this amplifier or speakers. This may void your
warranty.
Volume Regulator:
You can adjust the sound volume from minimum (the knob – max counterclockwise)
to maximum (the knob – max clockwise). Distortion and sound quality worsening
may occur when the knob is in the maximum position. It may damage the amplifier or
speakers. This may void your warranty.
Bass Regulator:
You can adjust bass output of the amplifier. The default: the knob is in the
center position : the marker on the knob in the vertical position. Turn the knob
counterclockwise (-) to decrease the amount of low frequencies. Turn the knob
clockwise (+) to increase the amount of low frequencies (+).
Treble Regulator:
You can adjust treble output of the amplifier. The default: the knob is in the
center position : the marker on the knob in the vertical position. Turn the knob
counterclockwise (-) to decrease the amount of high frequencies. Turn the knob
clockwise to increase the amount of high frequencies (+).
Balance Regulator:
If the center of the soundstage is off-center, rotate the Balance Regulator knob in the
direction that the soundstage needs to be moved. The default: the knob is in the center
position : the marker on the knob in the vertical position.
