Taga Harmony HTA-1200, Instruction Manual

Page: 10 / 16

10
Operation
1. Plug the Power Cable to the amplifier and into the electrical outlet.
2. Turn on the amplifier – press the Power Switch (the Power Switch should be in the
down position).
The status LED located on the Volume Regulator should turn red in a few seconds.
If it does not, it means that the amplifier is working in abnormal condition (a
protection mode) – turn off the power, unplug the Power Cable and check whether
some of the cables are not short circuited. After fixing the cables turn the amplifier
on.
3. By rotating the Input Selector knob on the front panel or pressing one of input
selector button on the remote controller, select which audio source you want to
play.
Make sure the audio source is properly connected to the rear panel inputs.
The selected source is indicated by one of LED indicators on the front panel.
4. Turn on your audio source and start playback.
5. Regulate volume on the amplifier to adjust the level of sound.
Note! Check “Additional Information” for other useful operating instructions.
Note!
High volume levels can damage this amplifier and/or speakers. This may void
your warranty.
Hooking up the Amplifier
console etc.) depending on a digital output your audio source is equipped with,
connect it to one of digital inputs: OPTICAL or COAXIAL. Use a digital optical
cable for the OPTICAL input and a digital coaxial cable for the COAXIAL input (the
cables are not supplied with this product).
6. Preamplifier Output (PRE OUT) : this amplifier is equipped with a preamplifier
output. Using an RCA interconnect cable (not supplied with this product) you
can connect to it external equipment (power amplifier, powered speakers, active
subwoofer etc.).
The PRE OUT level is variable controlled according to the Volume Regulator. All
sound regulations (Loudness / Bass / Treble) will affect the sound transmitted to
the PRE OUT.
7. If you want to listen to music via headphones : connect the headphones to the
Headphones output (check “Headphones connection” for more details).
Your amplifier is ready for operation.
Note! Avoid to short-circuit of cables – it can damage this amplifier or speakers.
This may void your warranty.
Note! Only speakers within range of impedance 4 - 8ohm can be connected.
Connecting speakers outside this range can damage this amplifier and/or
speakers. This may void your warranty.