5
3. TEST AND FUNCTIONING PRINCIPLE OF THE SYSTEM
Connect the antennas on the
receiver
and
transmitters
. The antennas must always be
positioned vertically. Use the adapter right angle BNC if the
receiver
is placed horizontally.
Switch ON the
receiver
by pushing approximately 3 seconds on POWER. The red LED is on
(see chapter 6 ).
Check the programmed "TEAM" (A, B, C or D) on the
receiver
and the
transmitters
. It must
be identical for each system. To change it, activate SET and press TEAM.
Check the programmed channel N° (CHANNEL) on each
transmitter
(1, 2, 3 or 4). This N°
corresponds to the OUTPUT N° of the
receiver
. This / or these OUTPUTS are connected to
the timing device. To modify the OUTPUT N°, activate SET and press CHANNEL.
Press TEST on the
transmitter
(transmission test)
-
The green LED of the
transmitter
(1 to 4) corresponding to the selected channel N° is on
and a “beep” signal confirms the sending of the impulse.
-
The green LED of the
receiver
corresponding to the channel N° of the
transmitter
(1 to 4)
is on and a “beep” signal confirms the reception of the impulse which is provided on the
corresponding output (1 to 4) to the timing device.
-
The 4 green LED’s on the receiver unit allows you to monitor the quality of the signals being
received.
1 led is on
- > Very weak Signal
2 led’s are on
- > Weak Signal
3 led’s are on
- > Signal satisfactory
4 led’s are on - > Good Signal
(see chapter 2. “Description of the system HL 610”)
At the end of the test or use of the system, do not forget to switch off the receiver !
Activate SET and press POWER
