•
Install this product horizontally on a surface within 0 to 20 degrees
tolerance (within 5 degrees to the left or right). Improper installation of the
product with the surface tilted more than these tolerances increased the
potential for errors in the vehicle’s location display, and might otherwise
cause reduced display performance.
•
When installing, to ensure proper heat dispersal when using this product,
make sure you leave ample space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
•
In order to prevent interference, set the following items as far as possible
from this product, other cables or leads:
- FM, AM antenna and its lead
- GPS antenna and its lead
- DAB+ radio antenna and its lead
- Digital TV antenna and its lead
In addition, you should lay or route each antenna lead as far as
possible from other antenna leads. Do not bind, lay or route them
together, or cross them. Electromagnetic noise will increase the
potential for errors in the vehicle’s location display.
•
When installing, make sure you remove the two screws on the top of the
product (for those models with the disc loading drive). Otherwise the drive
cannot accept discs.
Be sure to run the vehicle engine while using this product. Using this
product without running the engine can drain the battery.
WARNING
Do not install this product in a vehicle that does not have an ACC wire or
circuitry available.
To avoid battery exhaustion
